Power Squeegee – PS200

The Power Squeegee – PS200 is designed for via hole fill on high aspect ratio boards. This hand tool is especially for prototype boards with limited plugging areas like BGA’s or similar and process evaluation.

Function:

The paste is stored inside this tool and is pressed through the holes of the PCB’s with compressed air, which is controlled by a foot switch. You simply control the compressed air as you slowly fill the holes. This is a "one step" process and there is no risk of getting air bubbles inside the holes. When you are finished, the Power Squeegee PS200 is stored according to the manufacture’s recommendation.

Some of the recommended types of paste:

• DuPont, CB100 – Conductive Silver Paste
• Tatsuta, AE1190 – Conductive Copper Paste
• Peters, PP2795 – Non Conductive Epoxy Paste
• San-EI, PHP900 – Non Conductive Epoxy Paste
• Taiyo, THP100DXI – Non Conductive Epoxy Paste

Advantages:

• No clean up or change from the paste to storage containers
• Using up to 75 lbs. of pressure to push the paste through very high aspect ratio boards
• No direct contact between the compressed air and the paste

System Data:

Back to Equipment page